|
|
|
|
 |
 |
It is a sensonic(sensing) system that combines
both the conveniences of an auto-matic Transmission and the
economic-viability of a manually geared system.
In a manually geared system, you have to press down the clutch
pedal when you want to change the gear position.
However, since the Electronic Sensor at the hand knob of the
change lever in the Auto Clutch system will push or pull the
release poke, you do not need to press down the clutch-pedal,
and you will feel the same effect as driving an automatic
vehicle.
|
It can be installed to
all kinds of manual vehicles. (Passenger cars, 4WD, trucks,
buses, etc.)
When you are at a stop, if you keep the gear at the 1st position
and move the foot from Brake Pedal, the vehicle will slide smoothly
forward. The vehicle will come to a stop without engine stop,
if brake-pedal is pressed down. It works just like an automatic
vehicle.
No matter what positions the gear may be on, the vehicle can
come to a stop by just pressing the brake-pedal while driving.
During the traffic jam, the start is very smooth. It provides
satisfaction to the customers just like the automatic vehicle
does. When the gear position changes the vehicles do not jerk.
The engine does not stop even during a sudden start or brake. |
|
 |
1. No-Clutch Function
Like an automatic vehicle, start and stop can be conducted only
by the accelerator and brake system without using the left foot
as much as manual geared vehicles. Therefore the physical effort
is reduced while driving.
2. Interchange of Manual and Automatic(Multi-Function
System)
Whenever the clutch-pedal is pressed down, it changes to manual
state. Hence, the manual system and automatic system are interchangeable.
3. Economic-Viability and Environmental Concern
The fuel consumption is similar to an ordinary manually geared
vehicle, which means that the fuel consumption rate is 20%~30%
lower than the automatic one.
Therefore it is more economically viable. Along with this
advantage, the air pollution due to automobile exhaustion
is reduced, contributing to the environmental protection.
4. Target Vehicles
Installation is possible in all kinds of manual-geared vehicle.
(cars, jeeps, trucks, buses, etc.)
|
 |
|
 |
Like the automatic vehicle, the vehicle
needs the accelerator to be pressed down to start.
To stop, just press down the brake-pedal.
The engine will not stop when you press down only the brake-pedal.
Just change the gear position as manual with gently touching
the hand knob Sensor or Button. |
|
|
|
